Looking for Answers about Metal Accordion Side Table?

Yes, it will.

the base screws into the top so they are not adjustable once put together

The base does open wider but I'm not sure it will go down to coffee table height.

Yes, the base opens wider, but you would need a different sized top, and the base needs to screw into the top, so you'd have to find a top with 3 holes around the bottom.

Yes, it will open wider.

Yes, the base opens wider, but it doesn't get that much wider/shorter. I don't think it would work for a coffee table (unless you want a taller one)

The table does not fold at all. But it is perfect size and super easy to store.

Yes, the base will open wider. And you can screw the legs into your homemade tabletop.

Unfortunately the legs do not expand wider.

Nope. Only if you had a wielder

screws

The table top has 3 threaded built-in screws that stick out from the bottom. The legs have 3 prongs at the top with holes in them for the screws to sit in. They provide bolts to screw on to the threaded part, holding the top in place.

The base has holes that fixed bolts fit down into. The bolts are part of the table top.

You just unscrew the bolts, put the table on the legs, and screw the bolts back in. Super easy!

Nuts and an enclosed wrench. Very easy. Table top has affixed bolts that fit into slots on each leg. Once it is situated in place, screw the nuts onto the bolts and tighten with the wrench. Very easy. Can be done by one person.

You have to unscrew the nuts from the underside of the table, put the bolts through the holes on the top of the legs, and then screw the nuts back on. That took me a minute to figure out too!

The table comes with a set of printed instructions that tell you how to attach the tabletop to the legs.

All you have to do is turn the tabletop upside down and put the legs in the screws that are already part of the tabletop. Then screw the nuts over the screws. Most of this you can do by hand, but the table comes with a thin wrench for tightening the nuts.

There are screws that come out of the bottom of the table and little lug nuts that attach it together. Easy Peasy!

With a nut and bolt that comes with the table

I just set it on top

The top is 14" diameter

Just over 14 inches

The table top diameter is just under 14.5"

141/2 inches

14.5 in or 37 cm

14 inches from edge to edge.

Inside the rim, the diameter of the flat portion is 13.75". I know because I had a circular mirror cut to fit in it.

The diameter is 14-1/2".

14"

The feet are 14 inches apart. The top bolts on so it can only be used at this size. Won't work in a 10 inch space.

Table is 14.5" at it's widest point.

If you mean to set it up, no. It is a fixed diameter of 141/2 inches.

No.

the top is going to be too wide. I have it in a 14" space and it's just about perfect.

The tabletop is 14" in diameter, and the legs are about 25" long.

What do you mean when you say you have a 10" space? What's the length, width, and height of the space?

Nope its 14" in diameter

.Sticker on the bottom indicates China.

Made in China, of course...

I'm guessing about four to five pounds